Which camera?
From the spindle centre, in mm
Fit kit
One small print checks your printer and your camera first.
- Couponyou measure it
- Fit ringgoes into your camera
- Fit ring lidlets the door close on it
- Cup wheeltests the drive
One plate, about 25 g, under an hour.
Four caliper readings on the coupon, in mm.
| Correction | Coupon | In use |
|---|
| Outer faces | – | 0.00 |
|---|
| Holes | – | 0.00 |
|---|
| First-layer holes | – | 0.00 |
|---|
Set the corrections by hand
Never force anything. Stop at the first no.
Door open, wheel out
Something on the floor lifts it. If it rocks at the front edge, a deeper floor relief helps.
Door closed, camera off
The ring doesn't reach the front stops.
Too tall for this door.
Door open, lid and wheel out
Door open, look for shine
The camera's locating pin rubs.
The gate reaches further in than planned.
The rear springs don't reach the pads.
The spring lands in the charging window.
Cup wheel in, camera moving
Stop: the claw touches the ring. Don't run the camera with it; photograph the shine and send a fit report.
The drive doesn't catch the cup.
You changed a size by more than 0.3 mm: print another ring and check again.
Help the next builder with your camera.
Send it with a photo of the ring in the chamber via studiofabi.com/contact.
Review
Camera interface
Sensor
Your parts
Printing
Download
One part at a time
After printing
- Wire it and install the code kit: Wiring, Software.
- Add s8profile.json to the card or the cartridge's web page.
- Calibrate with s8test.py --calibrate, film, and .
Files: CC BY-NC-SA 4.0